Introduction

This guide explains how to remove the brush case from your Roomba.

Pièces

Aucune pièce nécessaire.

Place your Roomba upside-down on a hard surface.
  • Place your Roomba upside-down on a hard surface.

If all you need off is the faceplate, skip all of the screwdriver-based steps, and just remove the dirt bin(step 7) and start from step 11 at the rear.

David Forrest - Réponse

While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
  • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

Ajouter un commentaire

Gently pull upwards on the brush to remove it.
  • Gently pull upwards on the brush to remove it.

Ajouter un commentaire

Rotate the Roomba upside-down so the bottom is facing towards you.
  • Rotate the Roomba upside-down so the bottom is facing towards you.

Ajouter un commentaire

Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place. Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.
  • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

Ajouter un commentaire

Carefully lift the bottom plate.
  • Carefully lift the bottom plate.

  • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

Ajouter un commentaire

Push on the dirt bin release button, and pull gently.
  • Push on the dirt bin release button, and pull gently.

Ajouter un commentaire

Use a Phillips #1 screwdriver to loosen the 4 captive screws around the case .
  • Use a Phillips #1 screwdriver to loosen the 4 captive screws around the case .

Ajouter un commentaire

Grab the brush case and pull upwards to remove.
  • Grab the brush case and pull upwards to remove.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

John McTigue

Membre depuis le 31/01/2014

331 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 13-14, Regan Winter 2014 Membre de l'équipe Cal Poly, Team 13-14, Regan Winter 2014

CPSU-REGAN-W14S13G14

4 membres

13 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 464