Réparez vos affaires Communauté Boutique

4ème génération de l'Apple iPhone. La réparation est relativement simple, mais la vitre avant et le LCD doivent être remplacés ensemble. GSM / capacité de 8, 16 ou 32 Go / Modèle A1332 / noir et blanc.

2375 questions Voir tout

Options

Replaced full screen, digitizer works but no picture

Hi there,

Long story short... Broke the glass on my iPhone 4 and bought a replacement on Amazon for $20. I was skeptical but stay with me.

I work in a computer repair shop so I figured I was up to the task.

Did the whole repair and everything, and I've got no picture... not even a backlight. HOWEVER, the digitizer works because I can still unlock the phone without the display working (the phone makes the little unlock sound).

I plan to open it up again tomorrow and check connections but I figured I'd ask... could I have gotten a bad screen?

I've read where others have the backlight work but not the screen, but I don't have either... but the digitizer works and if I'm not mistaken, that was the smaller of the 2 cables that had to be fed back into the device.

Please advice.

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice -1
Ajouter un commentaire

1 Réponse

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Solution retenue

Options

Soft reset the iphone by holding down the sleep/wake and home button until you see the apple logo. If that doesn't work, go back in and check your lcd cable connections by re-seating them and also inspect the receptacle on the logic board to ensure you didn't accidentally break a gold pin. If none of that works then it is possible you have a LCD that is DOA.

Usually, the LCD cable will pop up on re-assembly and can be easily overlooked.

If your old LCD worked, you can connect it back -- without removing the new screen, to verify that the new LCD is defective. I always simply disconnecting the old lcd cables, without removing the old LCD, and connecting up any new lcd just for quick testing. I believe iFixit and other companies sell an extended length testing cable just for this purpose.

Cette réponse est-elle utile ?

Oui Non
Indice 2

2 commentaires:

Thank you for the detailed response. I performed a soft reset last night upon completion and I know no Apple logo appeared.

Once I get back from work today I will reopen the unit and confirm the LCD cable is in place. My last screen is pretty badly cracked, and I definitely added to the crack in its removal, but I can definitely pop it back in (as you suggested) to test.

I will follow up again this evening.

Cheers.

par

Just wanted to follow up and say that after taking it apart again, and reseating the LCD connector, followed by a soft reset, I was good to go!

I did accidentally not reconnect the cell antenna and found myself with no signal for about half an hour, but another 20 minutes later and I was good.

Cheers!

par

Ajouter un commentaire

Ajouter une réponse

Ben sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,970