Rep: 35
3
1
I replaced the digitizer on an iPad Mini and now the home button doesn't work. Not to be mistaken for the issue where the home button thinks it is always pressed. It is not responding at all. Anyone??
Cette question est-elle utile ?
Rep: 283
2
2
2
Have a look at this thread: iPad Mini Home Button Not Working After Digitizer Replacement
the answer was given by GtechRepair: "The easiest solution Is to go back to the old screen at the bottom where the Home button is located, There you will see two pieces of fabric tape, The one closest to the home button will be layered over a clear piece of tape, try to remove them together, use x acto knife to lift up corner, then a good pair of tweezers to peel it off.
Perform the same procedure To the fabric tape to the left, Then place both pieces down on your new digitizer, In the same place that they were in on the original. This should solve your problem 100%."
these black tapes go here:
Cette réponse est-elle utile ?
Same here :(
Cette réponse est-elle utile ?
Im going to try a new digitizer assembly when I can. Have you tried this?
Rep: 13
3
Rep: 13
3
NICE.. SWEET! (If only I hadn't thrown that old broken digitizer away :(
Cette réponse est-elle utile ?
Dernières 24 heures : 0
7 derniers jours : 0
30 derniers jours : 1
Total : 3,551
