My washer gets "stuck" between the rinse and spin cycle. It continuously fills until I manually move the dial. Once I move the dial, it finishes the load without incident. What part do I need to replace?
Cette question est-elle utile ?
Rep: 685,2k
3,4k
1,1k
2,6k
Lid Switch Assembly
If the washer stops mid cycle the lid switch assembly might be defective. This is a very common problem. The lid switch assembly can fail either mechanically or electrically. Test any electrical switches with an Ohm meter for continuity. The switches should have continuity according to their design.
Door Lock Motor and Switch Assembly
If the washer stops mid cycle the door lock assembly should be checked. The door lock can fail either mechanically or electrically. Test any switches on the door lock with an Ohm meter. The switches should have continuity according to their design.
Water Inlet Valve
If the washer stops mid cycle the water inlet valve cold water side may have failed. Most washers have a cold water rinse and so if they can't fill with cold water they just sit indefinitely waiting for the cold water to enter. If there is cold water to the water inlet valve and the cold water works in other parts of the cycle - or to make warm water - the valve is not the problem.
Main Control Board
If the washer stops mid-cycle the main control board might be defective. This is not common. Check other causes first such as the lid or door switch and other components.
Cette réponse est-elle utile ?
When water gets to the proper level the machine should start running in Rinse so you could have bad water level switch or bad timer you can try a can of electrical cleaner from Auto parts store to clean the old mechanical timers unplug first and give cleaner time to dry. Also the hose from tub to water level switch can get stopped up causing long fill times or no fill.
Cette réponse est-elle utile ?
Dernières 24 heures : 1
7 derniers jours : 17
30 derniers jours : 83
Total : 15,464
