Rep: 13
1
2
I'm doing a motherboard swap between 2 new 3DS XLs (US and Japan) and as I have done shell swappings on previous 3DS and DSs I was used to the old ZIFs so i opened the tab to get the wires out, but after the fact, I read on another question here that I'm not supposed to open the tabs on those, as they dont seem to be able to snap back. Am I screwed?
Cette question est-elle utile ?
Rep: 1,3k
9
4
3
I don't know if they can be snapped back (I actually snapped one off completely, ha ha), but the connector should still work. The ribbon will just slip out more easily, so be careful reassembling.
Cette réponse est-elle utile ?
try using a bit of tape on the cable and connector to help keep from it sliding out
zoe hey im new to the formus and sorry for necro but i need some help.
u mention that u snapped off one of the JAE FA1004SA1-R8000 connectors, well so did i and i need to know how do you replace them.
Also if there are any compatible connecters from other brands since JAE FA1004SA1-R8000 are not really avaible in EU unless i order from US and pay 40$ in shipping for 3$ worth of parts
What I did was take the cable out of the connector, place it back roughly where it's supposed to go, then apply a small amount of pressure to the BACK of the connector, opposite of where the cable goes in, where the 4 connects look like a hinge of sorts. Apply just enough pressure to see the connector bend down to where it's supposed to go. Pressing on the front of the connector, where the cable goes in, didn't do much for me. Still can't get my MIC to work... Still, light and home button work excellently.
Cette réponse est-elle utile ?
Dernières 24 heures : 0
7 derniers jours : 0
30 derniers jours : 4
Total : 814
