Réparez vos affaires Communauté Boutique

6ème génération de l'Apple iPhone, annoncé le 12 septembre 2012. La réparation de cet appareil est similaire aux précédents modèles et nécessite des tournevis et des outils pour ouvrir et faire levier. Disponible en GSM ou CDMA / 16, 32 ou 64Go / Noir ou Blanc.

2522 questions Voir tout

Options

iPhone 5 won't close tight after screen replacement

iPhone 5 won't close tight after screen replacement as shown in the photo:

Block Image

I have correctly lined up the screen at the top but it cannot fit at the bottom because the phone was smashed at the top of the rear case.

Block Image

It's just less than a mm, can I force it or should I buy a new rear case?

I have tried to "pull" the smashed part out of the phone but it's quite difficult, which tools do you suggest for that?

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 1
Ajouter un commentaire

2 Réponses

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Solution retenue

Options

I usually use a specific tool for this called "G-tool." Your alternative is to use pliers. There is a big risk of separating the bottom and top frame from the middle one, depending on which one you're trying to repair.

You can also file the frame of the phone. The plastic part, from the inside/bottom of the frame. Don't file the glass otherwise you'll ruin the screen.

Alao make sure nothing is pushing up such as a loose screw stuck to loud speaker or ear speaker. Make sure also you are tucking the screen underneath the top part of the frame them pushing down the bottom.

Cette réponse est-elle utile ?

Oui Non
Indice 2
Ajouter un commentaire

Options

The screen is an exact fit, if there is a dent stopping it from fitting straight then it's not going to fit properly.

There's so much you can get away with but if it's bad it won't fit.

Like Rany said g-tool is the best bet or use some pliers and protect the housing as much as you can cause it's likely to destroy it. Sometimes I shed parts of the bezel off with a razor blade to make it fit. It doesn't look any different.

Cette réponse est-elle utile ?

Oui Non
Indice 0

1 commentaire:

Do you mean I could try to shave the plastic frame of the screen assembly on the bottom as it appears in photo n.1? it's just a for a few that it doesn't close..anyway I am thinking about replacing the hole housing cover as I have already bought it, I think it is the best option.

I have checked out the G-Tool but it appears to be expensive and it's not available in Europe.

par

Ajouter un commentaire

Ajouter une réponse

uchika96 sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 1,407