Rep: 3,1k
26
5
8
Hello... trouble with the water heater.
First the pilot wouldn't lite.. so i turned it off for 10min to clear the gas and tried
it again and the pilot worked. I hold the pilot button down until the status flashes but
the pilot goes out when i let go the button. I was told there is a reset button so i pushed what i thought was the reset but it doesn't push or click. Any thoughts?
Cette question est-elle utile ?
Rep: 101,2k
8
172
358
@cameraparts4you , Be extremelly careful working with your gas appliance, if unsure contact a Qualified Technician. Dirty TC( thermocouple), faulty TC, pilot flame to not set properly/small or not close enough to TC, partially plugged pilot tube, faulty/bad gas control valve, all could cause pilot not to stay lit. Check the attached links troubleshooting,instruction, Good luck.
I hope this helped you out, if so let me know by pressing the helpful button.
Cette réponse est-elle utile ?
Dernières 24 heures : 8
7 derniers jours : 29
30 derniers jours : 89
Total : 23,712
1 commentaire
Tested the Thermopile and the mV reaches above 500 mV and continues to go up after about a minute of holding down the pilot button, but as soon as you let it go it drops back down to almost nothing.
par Sales Cameraparts4you