Aller au contenu principal

L'Apple iPhone 5s fut annoncé le 10 septembre 2013. La réparation de ce modèle est très similaire aux modèles précédents et requiert des tournevis ainsi que des outils pour faire levier. Disponible en version GSM ou CDMA, 16/32/64 Go de stockage et en argent, doré ou gris sidéral.

Questions au sujet de 4094 Voir tout

Won't turn back on

I took the iPhone 5s apart to clean some fluff from the rear camera but after reassembling it won't turn on. When I took it apart the first time it was stuck then suddenly opened and the home button flex cable connector and metal clip came off but it didn't look damaged. I've since replaced the home button and flex cable but it's still not turning on. Any suggestions ?

Update (01/07/2017)

Thanks

I've not got another battery but when I connect it to a PC iTunes starts and says can't connect to iPhone because it locked but nothing on the phone display

Répondre à cette question J'ai le même problème

Cette question est-elle utile ?

Indice 0
Ajouter un commentaire

3 solutions

Try swapping in a known good battery and charging port if you can get access to one. Then try plugging it into iTunes, if it turns on perfectly fine, then narrow it down to one part. If it doesn't connect to iTunes, your board is most likely bad.

Cette réponse a-t-elle été utile ?

Indice 0
Ajouter un commentaire

You have shorted the anode filter bead on the backlight circuit. A local repairer can fix this easy. Always remove the battery 1st!

Cette réponse a-t-elle été utile ?

Indice 0

Commentaires:

I suppose it's possible that I could have shorted some pins when re-attaching the 3 connectors on the top right while the battery was still connected, not my best move! I'm not sure if you can damage a filter cap by shorting it?

Is the backlight circuit on the logic board or the display?

par

hi Melfyn.

i can say for 100% on the 5s that the anode emi filter bead is blown. this is only a small part and is a quick fix for any repair technician. on the 5s the backlight driver ic , coil and diode rarely fail even when shorted. the filter bead is just below the lcd connector socket on the logic board

par

Ajouter un commentaire

Backlight ic is on the logic board, but if you are lucky and the ic isn't damage then a new screen will fix the problem, don't forget to disconnect the battery first and place the screws in the correct order ( to prevent damage the logic board ) on the metal plate that covers the 3 connectors of the screen.

Sorry for my poor English.

Cette réponse a-t-elle été utile ?

Indice 0

Commentaires:

Would this prevent the phone from switching on or just the display working? There's no vibration when I switch the silent switch on/off.

par

thats is why you dont see a image on the screen, when you take a torch and view from a angle may you can see the image.

par

Ajouter un commentaire

Ajouter une réponse

Melfyn Edwards sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 86