Rep: 1
1
Hey guys I was replacing the digitizer on my iPad 2 the other day and the lcd won't turn on. I haven't sealed it up yet but I have tried to force reset it and it didn't work. But when I plug it in I hear sounds. But also the screw that holds the battery connections to the logic board is stripped. So guys please help if you can
Cette question est-elle utile ?
Rep: 10k
15
29
4
Assuming your Home and Power buttons were both connected on the circuit whilst you did the hard reset, (Home adnd power for 20Sec),
take a flahs light to the screen and see if there is an image on it, without the backlight.
If this is the case, likely the backlight filter, or diode has blown. This is the most common failure for home repairs next to physical damage. Ususally caused by doing the repair while the device is on. this is a microsolder surface mount job. if you are comfortable with SMT repairs, then here
Cette réponse est-elle utile ?
What is the best way to tell if the home button is connected
Does the home button just connect to the two gold posts on top of the charger
yes. the button traces on the component itself pressure connects to the gold posts on the Charge Flex
Dernières 24 heures : 0
7 derniers jours : 0
30 derniers jours : 0
Total : 46
Also the iPad was on when I connected the LCD
par Thomas Covert