Rep: 1
1
I have just fixed an iPhone 6's screen for a Cutomer. And the screen is black. It works because iTunes recognises it.
Tried the old screen and also another screen and none of the 3 screens work.
Cette question est-elle utile ?
Rep: 221,4k
15
289
807
You may have blown the backlight circuit on the logic board. To be certain, shine a bright light on the screen after you connect it to an iTunes enabled computer. If you see a dim image, then the backlight circuit is damaged. This will require a micro-soldering repair.
Cette réponse est-elle utile ?
That's the thing, the display shows nothing! Yet iTunes recognises the phone. I have no idea what the issue could be.
Then you will need to look at the LCM Driver circuit (Chestnut).
Rep: 34,6k
10
22
44
is there image and no backlight ?
Cette réponse est-elle utile ?
The backlight doesn't work either
Rep: 14,9k
8
29
40
Take Diode Mode readings of the FPC's and compare to 1st image, check Filters for continuity...For backlight, pay attention to image 2, and for image, you can start with 3 - 5, but may also find LCM Reset, Photon alive, etc while looking through diode mode readings if off...
Cette réponse est-elle utile ?
Rep: 187
5
1
sounds like you blew the backlight 99% of the time that happens because the battery was not disconnected during the repair
Cette réponse est-elle utile ?
Oh crap! How do I fix that?
you have to change the filter are you good with microsoldering?
I'm not good with it no. I don't even have the right equipment
where are you located? check shops around you or you can just send it in
Dernières 24 heures : 0
7 derniers jours : 0
30 derniers jours : 0
Total : 123
