Réparez vos affaires Communauté Boutique

iPhone 4 pouces commercialisé depuis mars 2016 avec une configuration de matériel similaire à l'iPhone 6s. Disponible en Argent, Gris sidéral, Or ou Or Rose, avec 16 ou 64 Gb de stockage. Modèles A1662 et A1723.

1049 questions Voir tout

Options

u4020 critical to boot?

Good afternoon,

I'm just researching a water damaged iPhone SE that initially had a VCC_Main shorted that was alleviated by removing one cap.

When connecting to power now, it draws 0.43mA / 0.44mA and U4020 LED Driver gets really hot (freeze spray used to detect).

It controls the "LED Driver" and schematics says it is critical. Is it critical for boot? or if we remove this should we be able to artificially use a light and go into the screen layers?

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

1 Réponse

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Solution retenue

Options

Just to confirm, U4020 is not Stockholm but the Backlight Driver IC. A damaged or defective backlight driver doesn’t stop the phone from booting, unless it is pulling down PP_VCC_MAIN. So check VCC_MAIN to see if it is short or or not giving the proper voltage.

Obviously, a missing backlight driver doesn’t affect the boot either.

You should also probe the backlight circuit as if U4020 is hot, then one of the caps may be shorted on the output side.

Cette réponse est-elle utile ?

Oui Non
Indice 3

6 commentaires:

Thank you Minho, Not sure how I got this confused thinking it is Stockholm, must have had different schematics up or something. Will check the VCC_Main voltage and see

par

VCC_Main is low! 2.9V, I will remove this and see if it helps things.

par

VCC_Main short up to 3.6V now but still power being drawn is 0.45mA, no obvious signs of heat but removing this chip helped because there was a lot of corrosion, even under it!

Any ideas of probing further with this at all? I really appreciate your help!

par

What do you mean by "VCC_Main short up to 3.6V " ?

par

Using a multimeter in DC voltage mode VCC_Main is reading at 3.68V, before removing the LED Driver this was a lot lower

par

Afficher 1 commentaire en plus

Ajouter un commentaire

Ajouter une réponse

Elliot sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 156