Réparez vos affaires Communauté Boutique

Modèle A1419 / Fin 2012 / Processeur 2.9 & 3.2 GHz Core i5 ou 3.4 GHz Core i7, ID iMac13,2

330 questions Voir tout

Options

Worstcase happend - Display has dropped after replacement of hdd

Hi Folks.

I went trough all the steps and doesn’t missed anything. However after 1 week the display was dropped over the night. Luckely all connector seems fine and not broken the display is also save. To not run again into it - what did I wrong? All glue stribes where sitting on the right place. In addition, I didn’t get the display off again, after which I put it back temporarily. Does one have to press the display for a longer time to avoid that. I'm frustrated. Hope to get some help.

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 0
1 commentaire

Hey , thanks guys.

No I don’t forgot to replace the adhesive stripes. It could be possible that I didn’t clean it as needed. Will do that after the new stripes arrived. Many thanks. Will report …

Marc

par

Ajouter un commentaire

2 Réponses

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Solution retenue

Options

Sounds like you forgot to replace the adhesive strips:

Remplacement des bandes adhésives d'un iMac Intel 27" EMC 2546

Cette réponse est-elle utile ?

Oui Non
Indice 2

2 commentaires:

Did you fully clean the old adhesive?

I use Goof Off but it leaves a film which needs to be cleaned off as well.

par

I use GooGone. But also a pocket knife and catch the edge and peal it right off.

par

Ajouter un commentaire

Options

This is pretty much why I never service these in my repair shops. If one of these breaks on a client that's $200+ lost on a screen. Personally on one of mine I use masking tape easy to take off and put back on (transparent scotch tape is best) to keep the screen on the corners.

Cette réponse est-elle utile ?

Oui Non
Indice 1

1 commentaire:

@benjamen50 - No need for the exposed masking tape! I haven had a screen fall off on the systems I've fixed. Just like iPad's the technique is mostly the trick here.

After fully cleaning the edge and mounting the tapes I use a tongue suppressor to press the tapes down fully before peeling off the top sheets as I mount the display.

Next, after the display is mounted which is done when the system is flat on its back (I made a set of wood blocks to support the system this way. I then use a rubber roller to press the display glass down around the edge. Thus both sides of the tape have been firmly pressed into the surfaces they mate into.

par

Ajouter un commentaire

Ajouter une réponse

Marc Fiedler sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 81