I have a dual motor lift-board. I’ve had it for a while now but it’s been a since I’ve ridden it. It was good when I was using it. Now I’m trying to start using the board again and it won’t charge. The light keeps blinking red and I don’t know what to do. How do I fix this problem and if I can’t fix it can y’all fix it?
Cette question est-elle utile ?
Rep: 1,1k
5
5
1
Battery could have discharged too far. Recommendation is to get the wheels spinning for 10-15 minutes (they even go as far as saying to be pulled behind on bike) at roughly 10MPH. Check your remote to ensure it gets a little bit of a charge then try charging again.
I'm not sure what type of batteries these run but if they are LiPo, if not stored properly it can cause issues.
Cette réponse est-elle utile ?
Dernières 24 heures : 0
7 derniers jours : 8
30 derniers jours : 22
Total : 2,237
1 commentaire
Is there a pattern to the blinking? How long has it been plugged in?
par mayer