Trying to read pcb
is this tolerance or what?
Cette question est-elle utile ?
This particular guy is a weird one. There’s actually not a resistor in that position, it’s a filter. On the other hand—this filter doesn’t go bad. What makes you looking at battery_swi line?
Cette réponse est-elle utile ?
I don’t think he has a problem with any device. He is trying to understand what symbols and abbreviations mean on schematic diagrams.
U r right ????@imicrosoldering
Yes this is the tolerance of the resistor. They usually have a tolerance of 1, 2, 5, 10 and 20 percent. These values are to indicate how much the component can vary from it’s from its nominal value.
Cette réponse est-elle utile ?
@seif_mohamed I will post this on your previous question about MF
Dernières 24 heures : 0
7 derniers jours : 0
30 derniers jours : 0
Total : 94