Réparez vos affaires Communauté Boutique

Infos et tutoriels pour réparer l'iPhone 8, sorti le 22 septembre 2017, modèles A1863, A1905.

872 questions Voir tout

Options

I have an iPhone 8 that would not be detected by computer

I have an iPhone 8 that is currently on a boot loop. I put it in restore mode and connected it to the computer. The computer won't detect the phone. I tried another iphone the same cable and it connected. So I know it's not the cable nor the computer.

When the bad iPhone battery dies and it's connected to the computer, the apple logo comes on suggesting that it's charging however it won't be detected by computer and iTunes if place in recovery mode.

Can someone help me? Is this a hardware issue with the port? If yes, how so that it charges normally when connected to power and PC? What can I do?

Thanks

Répondre à cette question J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

1 Réponse

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s

Options

hello akinlolu,

if there is a problem with the charging port, please use inductive charging. This way you will charge your battery and you can move on. Unfortunately, I'm afraid your problem lies on much deeper than you think. You don't write about the last moments of your phone - this often turns out to be important information. I think you should find a good repair shop. If the technician will wants to replace the charging port right away, find another (good!) Repair shop.

Cette réponse est-elle utile ?

Oui Non
Indice 0

3 commentaires:

Thank you so much for the response. I went ahead and tested a new charging port and the phone boot up and worked. So I replaced, powered on the phone before closing the screen. Phone worked great, when I closed the screen back in place, it won't come on. So I opened it again, checked every connections and the screen came on. After this I closed back the screen and it refused to come on. So now I'm stuck on what to do.

Why does it work when screen is opened and then refused to work when screen is put together.

par

@akinlolu Is the back plate secured to the screen? In my experience this commonly happens when the back plate is not moved across during a screen replacement, and the display and touch cables are caught between the screen and frame, preventing the screen from functioning until the pressure on the cables is released(opening device back up). Ensure that the back plate is secured correctly and the display and touch cables from the screen aren't being mushed around or squished when you're putting the screen back down!

par

the only known and tried method in such cases is to return to the previous state. Take out the new tape and close the phone without it. Before that, however, check what happens when you close a working phone (it works with an open screen - close it when it is turned on). Important question: when you close the screen and the phone won't turn on (with new tape, speaker and taptic engine installed) doesn't the phone turn on or the screen? Check if the phone vibrates, makes sounds. You can connect it to a computer and see it on its screen. This looks like an accessory problem (you may have damaged screen tapes or the grounding of the new charging port is faulty - it happens in Chinese parts)

I assume you didn't damage your electronics while removing the connectors from the motherboard

par

Ajouter un commentaire

Ajouter une réponse

akinlolu sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 1

30 derniers jours : 1

Total : 34