Aller au contenu principal

Deuxième génération de l'iPhone. Modèle A1241 / capacité de 8 ou 16 Go / coque arrière noire ou blanche. La réparation est plus simple que pour l'iPhone de première génération et nécessite des tournevis, des outils pour faire levier et une ventouse.

1158 questions Voir tout

Home button not working after dissassemble

Hello I recently dissassembled my iPhone to change the volume button and after re-assembly the Home Button stopped working.

I already checked the gold prongs on the back, and made sure that the dock connector was properly assembled. But still not working....any ideas ?

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Indice -1
Ajouter un commentaire

2 Réponses

Solution retenue

On the logic board, under where the Home button is, you'll find the home button flex cable. You might check that the button on the flex cable is working, if not, you may need to replace it. I use a jewelers 30x loupe to check the cables for any slight tears.

Block Image

Cette réponse est-elle utile ?

Indice 6

6 commentaires:

Check the Home Button Flex for continuity with a volt meter when you push the Home Button. Also for the Home Button to work, Flex Cable #4 (the dock connector Flex Cable) must be seated correctly to the Logic Board.

par

+ love the pic you've added here John.. Gustavo, is this the same problem as your other question? If so it helps to keep just to asking once...we'll keep troubleshooting both otherwise and give the same advice again. if the above tips don't work then you may need a new dock connector :-(

par

Going to try a new dock connector, thank you. And yes pollytintop sry :(

par

John, if you intent to keep giving good answers, please fill out some on your profile so we can get to know you ;-) Thanks

par

@Gustavo - Glad you got it nailed down Gustavo. Good luck on your repair and if you have any questions there are always many fine members here that are more than willing to lend some sound advice.

par

Afficher 1 commentaire en plus

Ajouter un commentaire

Good way to check whether dock connector or not is to simply jump the contact pads with a screwdriver. If you get the same result as if you had pressed the button. then your problem is in the flex.

Another common mistake I've seen people make during screen repairs is simply pressing the prongs down during screen removal. Since it's not outright damaged it often gets overlooked, but if they are compressed they will not be making a connection.

Cette réponse est-elle utile ?

Indice 1
Ajouter un commentaire

Ajouter une réponse

Gustavo Camacho sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,398