Rep: 1
3
I just replaced the laser in an old gc, and it's moving, but the disk isn't spinning up. Not sure if that was already happening or if it's a new problem though. What can I try now?
Update: took it apart again to check for that solder ball, and now the disc spins, but the laser doesn't turn on
Cette question est-elle utile ?
Rep: 551
9
8
13
Go back over the connections you disconnected and make sure they are all connected correctly.
Cette réponse est-elle utile ?
Rep: 2,2k
17
15
5
Dernières 24 heures : 0
7 derniers jours : 1
30 derniers jours : 4
Total : 100
2 commentaires
@sadmango, Did you remove the solder ball all lasers are supposed to be shipped with to make it transport safe?
par Geir Ove Andersen
no, i didn't know there was one
par just some mango