Rep: 13
1
I turn it on to STIR. It runs smoothly for a few seconds and then stops. It runs well and smoothly at other speeds so I suspect it is not a damaged gear. Why would it come to a stop so soon after starting cold.
Cette question est-elle utile ?
Rep: 1
1
If your KSM3316X stand mixer runs fine at other speeds but consistently stops shortly after starting on STIR, it’s almost certainly an electrical or control board issue, not a mechanical one. The STIR setting uses lower voltage and torque, relying more heavily on the governor or phase control board to regulate power. A failing governor, faulty phase control board, or worn carbon brushes (less likely but possible) can cause the motor to cut out under the low-load condition unique to STIR. Cold start issues point to failing electronic components that stabilize as they warm up at higher speeds. I’d bet on the phase control board; swap it out first.
Cette réponse est-elle utile ?
Dernières 24 heures : 0
7 derniers jours : 3
30 derniers jours : 14
Total : 310
