Aller au contenu principal

Version revisitée de l'iPhone 3G avec une vitesse de traitement plus élevée. La réparation de ce modèle est similaire à celle du 3G et nécessite de simples tournevis et outils pour faire levier. Modèle A1303 / capacité de 16 ou 32 Go / coque en plastique noir ou blanc.

Questions au sujet de 1615 Voir tout

iPhone constantly searching for signal and end up with No Signal

I have opened my iPhone 3GS to replace battery. I am not sure what was the damage I have done to my phone. After reassembly, it's searching for signal and finally says no signal. I gave the phone to local repair shop, they have tried changing the doc connector from a working phone but still no luck. I have made the small copper tooth near connector 7 touching the silver frame. Still no luck. I suspect connector 7 on the mother board is damaged. I have attached my mother board pics here.

Has anyone faced this issue and replacing connector 7 male connector in the board will solve the issue?

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Indice -1
Ajouter un commentaire

3 solutions

Solution retenue

looks more like the screw hole is damaged? might be the corner of the motherboard has been flexed and cracked the internal wiring from no7 to antenna reception or there is not good contact with the little gold pin on the top of the dock connector. this a 3G but the idea is similar..

I'd try Gido's advice about testing the blue coil first though.

Cette réponse a-t-elle été utile ?

Indice 2
Ajouter un commentaire
Réponse la plus utile

Your connector looks somewhat damaged indeed. If it does not fit well it could cause a bad connection which can result in the problem you are facing.

I have replaced several of these connectors on the motherboard successfully to repair this kind of problem.

You may also want to check if the blue coil near the connector is still OK. These also tend to break. You can measure this with a multimeter. Should be between 0-10 ohms or so.

Cette réponse a-t-elle été utile ?

Indice 2


Many thanks for helping. I will arrange a multimeter to check the blue coil. Meanwhile, can you please tell me how much it would cost to replace connector 7 in the board?


Connector is quite cheap, a few dollars or so, if you are able to replace it yourself.

Normal price for a repair by a technician is somewhere around 50 euros or so (at least that is what I normally charge for this kind of repair).


Ajouter un commentaire

you can get theiphone signal inductor coils here





Block Image

Cette réponse a-t-elle été utile ?

Indice 0
Ajouter un commentaire

Ajouter une réponse

sayhiworld sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 1

Total : 2,468