Version actuelle par : iRobot

Titre:

Power button won't work after wifi & screen replacement

Texte:

So I had to replace the screen and during the process I ripped the wifi antenna. I ordered that and put it in no problem. Now before applying the Adhesive Strips I wanted to make sure everything worked. I tired holding the power button and it won't turn on (yes all the ribbon cables are attached). I plugged it into a power supply and it booted and the digitizer seemed to work ok, but not the power button.  To turn it off I had to unscrew the logic board and lift it from the battery packs.  Any ideas?

Appareil:

Statut:

open

Modifié par : iRobot

Titre:

Power button won't work after wifi & screen replacement

Texte:

So I had to replace the screen and during the process I ripped the wifi antenna. I ordered that and put it in no problem. Now before applying the Adhesive Strips I wanted to make sure everything worked. I tired holding the power button and it won't turn on (yes all the ribbon cables are attached). I plugged it into a power supply and it booted and the digitizer seemed to work ok, but not the power button.  To turn it off I had to unscrew the logic board and lift it from the battery packs.  Any ideas?

Appareil:

iPad 2 Wi-Fi

Statut:

open

Modifié par : Walter Galan

Titre:

Power button won't work after wifi & screen replacement

Texte:

So I had to replace the screen and during the process I ripped the wifi antenna. I ordered that and put it in no problem. Now before applying the Adhesive Strips I wanted to make sure everything worked. I tired holding the power button and it won't turn on (yes all the ribbon cables are attached). I plugged it into a power supply and it booted and the digitizer seemed to work ok, but not the power button.  To turn it off I had to unscrew the logic board and lift it from the battery packs.  Any ideas?

Appareil:

Statut:

open

Contribution d'origine par : Brian

Titre:

Power button won't work after wifi & screen replacement

Texte:

So I had to replace the screen and during the process I ripped the wifi antenna. I ordered that and put it in no problem. Now before applying the Adhesive Strips I wanted to make sure everything worked. I tired holding the power button and it won't turn on (yes all the ribbon cables are attached). I plugged it into a power supply and it booted and the digitizer seemed to work ok, but not the power button.  To turn it off I had to unscrew the logic board and lift it from the battery packs.  Any ideas?

Appareil:

iPad 2 Wi-Fi A1395

Statut:

open