Aller au contenu principal
Aide

Version actuelle par : Rany ,

Texte:

Hi Sam,
 
Are you following an iFixit guide?
 
If not, go to [[Topic:iPhone 5s|that page]], choose the guide that you need, and you will see that there are steps that indicate what screws go where, and their respective sizes. You will need an accurate measuring tool such as [product|IF145-016|this caliper] to measure the length, and trace each screw back to it's original place in the phone.
If not, go to [[Topic:iPhone 5s|that page]], choose the guide that you need, and you will see that there are steps that indicate what screws go where, and their respective sizes. You will need an accurate measuring tool such as [product|IF145-016|this caliper] to measure the length, and trace each screw back to it's original place in the phone.
 
The most important screws to watch out for are those that hold the shield covering the screen connectors.
 
If in doubt, don't put any there. If you use a screw that's too long, it will rip through the board, potentially breaking traces within the board and causing very expensive damage.

Statut:

open

Contribution d'origine par : Rany ,

Texte:

Hi Sam,

Are you following an iFixit guide?

If not, go to [[Topic:iPhone 5s|that page]], choose the guide that you need, and you will see that there are steps that indicate what screws go where, and their respective sizes. You will need an accurate measuring tool such as [product|IF145-016|this caliper] to measure the length, and trace each screw to it's original place in the phone.

The most important screws to watch out for are those that hold the shield covering the screen connectors.

If in doubt, don't put any there. If you use a screw that's too long, it will rip through the board, potentially breaking traces within the board and causing very expensive damage.

Statut:

open