Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Aide

Version actuelle par : cityzen ,

Texte:

The thing that looks like an antenna port in step 12 is actually a test connector (called a "test switch"). You'll notice it has a hole in the middle instead of a pin. However, you can see the circuit board trace coming from this part that carries the signal from the antenna connector on the other side (see step 11). If this trace is cracked, then you could conceivably repair it by very carefully stripping away the coating to expose the copper and soldering a tiny bead of solder across the break. The main difficulty is that it is so tiny; you'd need steady hands and of course a low wattage soldering iron with an extremely fine tip.
 
Btw, the antenna port doesn't connect to the case; it connects to the antenna. See label 7 in step 7.

Statut:

open

Contribution d'origine par : cityzen ,

Texte:

The thing that looks like an antenna port in step 12 is actually a test connector (called a "test switch").  You'll notice it has a hole in the middle instead of a pin.  However, you can see the circuit board trace coming from this part that carries the signal from the antenna connector on the other side (see step 11).  If this trace is cracked, then you could conceivably repair it by very carefully stripping away the coating to expose the copper and soldering a tiny bead of solder across the break.  The main difficulty is that it is so tiny; you'd need steady hands and of course a low wattage soldering iron with an extremely fine tip.

Statut:

open