Aller au contenu principal
Aide

Version actuelle par : jonathan ,

Texte:

These Motorola says to use a #00 phillips but IMO a #000 fits a little deeper into it. I make sure to a)press down hard b) make sure I'm pressing down at exactly a right angle. It's a tough job. [http://www.inovagent.com|Motorola DROID repair]
 
Wait I just saw Doug's first post..they are "thread forming?" That sounds suspiciously like "self-tapping" which would make sense as far as how tight they are in there. Whenever I take them out there is bare metal on the threads, even though the screws themselves are black.
 
Steady, hard pressure downward with a #000 bit using T-handle thing I created myself is the key, since I started using this self-made tool I haven't been unable to remove these screws and re-use them.

Statut:

open

Message d'origine par : jonathan ,

Texte:

These Motorola says to use a #00 phillips but IMO a #000 fits a little deeper into it.  I make sure to a)press down hard b) make sure I'm pressing down at exactly a right angle.  It's a tough job.  [http://www.inovagent.com|Motorola DROID repair]

Statut:

open