Aller au contenu principal
Aide

Version actuelle par : Ben ,

Texte:

The Type-C port requires a lot of heat to remove. Have you added leaded solder on the charging port pins to lower the melting point of the solder?
Leaded solder has a lower melting point compared to non-leaded solder which will be what the components on the logic board are soldered with.
+
+
+
+Check out this video for reference:
+
+https://www.youtube.com/watch?v=Wfx3ShJCxrA
+
+
+
+A board preheater (This helps a lot) is used along with a soldering iron and a hot air gun at the same time to remove the type-C port.

Statut:

open

Contribution d'origine par : Ben ,

Texte:

The Type-C port requires a lot of heat to remove. Have you added leaded solder on the charging port pins to lower the melting point of the solder?

Leaded solder has a lower melting point compared to non-leaded solder which will be what the components on the logic board are soldered with.

Statut:

open