Aller au contenu principal
Aide

Contribution d'origine par : jayeff ,

Texte:

Hi @albert4536 ,

You need to open the phone and clean it properly.

''The water causes corrosion and provides circuit paths for the electricity which were not in the phone's operating design and could damage the components. The corrosion starts immediately and is ongoing until it has been properly cleaned away.''

''First '''do not turn on your phone''' and then '''remove the battery as soon as possible''' from the phone'' to minimize any further damage.

Then you need to dis-assemble the rest of the phone and clean ''all the affected parts'' using '''Isopropyl Alcohol 99%+''' (available from electronics part stores) to remove all traces of corrosion and water. If possible do not use "rubbing alcohol" as in some cases this is <70% IPA, can contain additives and is not as effective. If you do have to use it check the label to verify the  amount of IPA. The higher the percentage of IPA the better

Here is a link that describes the process. [[Electronics Water Damage]]

As always with electronics, especially surface mounted pcb, be gentle when handling and especially when brushing away the corrosion. You do not want to remove any components from the board. You will also have to remove any shields that may be covering some components and check under them as well. Also any flex cable connections need to be disconnected and the cable ends and the connectors need to be cleaned as well.

Hopefully after you have done all this the phone ''might'' possibly work correctly again.

Here is a link to a teardown [https://www.youtube.com/watch?v=kmdlH2tkeqU|video] for your phone, which may be of some help.

If you decide to do this, ''do it sooner than later'' as it’s not going to fix itself.

Statut:

open