You could in theory replace the display on this, but I'm not sure if you can just get a new display and put it in. Presumably the display is connected to some hardware/firmware combination that expects this particular display.
So unless Steelseries opened up a spare part shop, where you could buy replacement parts, the official answer is; no. However, you can ***''(probably)''*** buy broken base stations to use for spare parts, depending on what's broken of course.
+
Here is an image of the screen part, which I guess is glued in some plastic frame thing that sits inside the base station enclosure.
+
[image|2670226]
+
+
***Side note!*** ''It's not really too bad to take the base station apart to replace parts in it. Just have to slightly lift the glued rubber base in each corner to find the screws, then carefully loosen the clips. ***Though be careful, this base station is very clearly not meant to be taken apart with ease, so some of the wires are very short and soldered on to the PCBs.***''
You could in theory replace the display on this, but I'm not sure if you can just get a new display and put it in. Presumably the display is connected to some hardware/firmware combination that expects this particular display.
So unless Steelseries opened up a spare part shop, where you could buy replacement parts, the official answer is; no. However, you can ***''(probably)''*** buy broken base stations to use for spare parts, depending on what's broken of course.
[image|2670226]