Outils recommandés dans ce démontage

Introduction

LED touch light Teardown

Cette vue éclatée n'est pas un tutoriel de réparation. Pour réparer votre Flashlight, utilisez notre manuel de réparation.

The assembled light.
  • The assembled light.

Ajouter un commentaire

Twist the mounting plate clockwise, then lift to remove it.
  • Twist the mounting plate clockwise, then lift to remove it.

Ajouter un commentaire

Remove the three AAA batteries from their holders.
  • Remove the three AAA batteries from their holders.

Ajouter un commentaire

Loosen and remove the four Phillips screws.
  • Loosen and remove the four Phillips screws.

Ajouter un commentaire

Having removed the four Phillips screws in the previous step, separate the assembly as shown.
  • Having removed the four Phillips screws in the previous step, separate the assembly as shown.

Ajouter un commentaire

Remove the three springs.
  • Remove the three springs.

Ajouter un commentaire

Using the craft knife, prise and loosen the three tabs shown from their mounting points. This will make removing the battery contacts easier in the next step.
  • Using the craft knife, prise and loosen the three tabs shown from their mounting points. This will make removing the battery contacts easier in the next step.

Ajouter un commentaire

Remove the battery contacts from their mounts, taking care to separate the soldered electrical wires without damaging nearby parts. Note the two smaller contacts which connect to the circuit board.
  • Remove the battery contacts from their mounts, taking care to separate the soldered electrical wires without damaging nearby parts. Note the two smaller contacts which connect to the circuit board.

Ajouter un commentaire

Using the craft knife, slice off the black plastic extrusions at the indicated positions. These tabs secure the circuit board to the main assembly.
  • Using the craft knife, slice off the black plastic extrusions at the indicated positions. These tabs secure the circuit board to the main assembly.

Ajouter un commentaire

Lift and separate the power switch from the main assembly.
  • Lift and separate the power switch from the main assembly.

Ajouter un commentaire

Using a similar technique to that exercised in step 9, slice off the clear plastic extrusions at the indicated positions. These extrusions secure the lens, case and reflector elements.
  • Using a similar technique to that exercised in step 9, slice off the clear plastic extrusions at the indicated positions. These extrusions secure the lens, case and reflector elements.

Ajouter un commentaire

The separated lens, case and reflector elements.
  • The separated lens, case and reflector elements.

Ajouter un commentaire

The full assortment of separated parts.
  • The full assortment of separated parts.

Ajouter un commentaire

Vimal

Membre depuis le 21/07/2013

210 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 9

30 derniers jours : 34

Total : 2,176