Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

  1. Firstly Disconnect  battery Always take the negative terminal off first.
    • Firstly Disconnect battery

    • Always take the negative terminal off first.

    • '''General Tip After disconnecting the battery leave the car for about 10 mins , This lets any residual energy left in the electrical system to dissapate. It is good practise whatever the job

  2. Unlatch the two clasps, as outlined in the image. Loosen the screw on the metal band, using a flathead screwdriver.
    • Unlatch the two clasps, as outlined in the image.

    • Loosen the screw on the metal band, using a flathead screwdriver.

  3. Disconnect the electronic sensor from the MAF. Press on the 2 latches, pulling the cable away from the sensor.
    • Disconnect the electronic sensor from the MAF.

    • Press on the 2 latches, pulling the cable away from the sensor.

  4. Le kit d'outils Essentiel

    Les outils les plus utiles dans notre kit le plus compact.

    J'achète

    Le kit d'outils Essentiel

    Les outils les plus utiles dans notre kit le plus compact.

    J'achète
  5. Disconnect the rubber hose from the MAF. Remove the MAF from the air filter housing.
    • Disconnect the rubber hose from the MAF.

    • Remove the MAF from the air filter housing.

  6. Steps 4-6 are for cleaning only.
    • Steps 4-6 are for cleaning only.

    • Spray the MAF cleaner along the direction of travel, shown by the arrow on top of the sensor.

    • (Mass Air Flow sensor Cleaner)

  7. Clean the electronic coupling with an electronics cleaner. Clean the electronic coupling with an electronics cleaner.
    • Clean the electronic coupling with an electronics cleaner.

  8. Inject conducting lubricant into  the MAF sensor electronic coupling. Inject conducting lubricant into  the MAF sensor electronic coupling.
    • Inject conducting lubricant into the MAF sensor electronic coupling.

  9. Reattach the MAF to the air filter housing and the intake hose. Tighten the screw on the metal band. Latch the clasps on either side of the MAF.
    • Reattach the MAF to the air filter housing and the intake hose.

    • Tighten the screw on the metal band.

    • Latch the clasps on either side of the MAF.

  10. Reattach the electronic cable to the MAF.
    • Reattach the electronic cable to the MAF.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Isaac Nitschke

Membre depuis le 11/10/2010

67 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 3-28, Regan Fall 2010 Membre de l'équipe Cal Poly, Team 3-28, Regan Fall 2010

CPSU-REGAN-F10S3G28

4 membres

9 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 1

7 derniers jours : 10

30 derniers jours : 18

Total : 8,571