Introduction

When a car is driven, tires tend to wear unevenly. To extend the life of tires, it is important to rotate the tires every 30,000 miles. This guide will show you how to remove and rotate tires.

Outils

Pièces

Aucune pièce nécessaire.

Turn car off and remove keys from ignition.
  • Turn car off and remove keys from ignition.

  • Place car in park (automatic) or neutral (manual).

  • Engage parking brake.

Ajouter un commentaire

Use hydraulic jack on frame of car to raise car.
  • Use hydraulic jack on frame of car to raise car.

  • Place jack head underneath frame of car.

  • Only necessary to jack the car until the wheels are just off the ground.

Ajouter un commentaire

  • Place jack stand on frame of car and remove jack.

  • Do no work under car supported only by hydraulic jack, serious injury or death may occur.

Ajouter un commentaire

  • Turn car off and remove keys from ignition.

  • Place car in park (automatic) or neutral (manual).

  • Engage parking brake.

Ajouter un commentaire

  • Use hydraulic jack on frame of car to raise car.

  • Place jack head underneath frame couple (pictured).

  • Only necessary to jack the car until the wheels are just off the ground.

Ajouter un commentaire

  • Place jack stand on frame of car and remove jack.

  • Do not work under car supported only by hydraulic jack, serious injury or death may result.

Ajouter un commentaire

  • Pry off the all four hub caps by placing a small flathead screwdriver between hubcap and rim pulling the screwdriver away from tire.

  • Pull hubcaps away from tires.

Ajouter un commentaire

  • Loosen each of the five lug nuts on all tires by turning them counter-clockwise with a 19mm wrench.

Ajouter un commentaire

  • Remove tires by pulling directly away from car exposing brake rotors.

Ajouter un commentaire

  • Swap tires according to diagram.

Ajouter un commentaire

  • Place tires on axels.

  • Hand tighten the lug nuts with narrow end of nut towards car.

  • Finish tightening the lug nuts with 19mm Torque Wrench to a torque of 63 lb*ft.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Garrett Van Ruiten

Membre depuis le 11/10/2010

51 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 3-28, Regan Fall 2010 Membre de l'équipe Cal Poly, Team 3-28, Regan Fall 2010

CPSU-REGAN-F10S3G28

4 membres

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 2,315