Aller au contenu principal
  1. Using plastic pry tool. Pry silver cover from handle.
    • Using plastic pry tool. Pry silver cover from handle.

  2. Using plastic pry tool. Pry Control panel off which controls locking, unlocking and windows.
    • Using plastic pry tool. Pry Control panel off which controls locking, unlocking and windows.

  3. Un-attach white header(connector) from control panel. Push side tab on side of white connector if a little stuck.
    • Un-attach white header(connector) from control panel. Push side tab on side of white connector if a little stuck.

  4. Using pry tool. Pry off plastic plate in section of door lock or pull handle.
    • Using pry tool. Pry off plastic plate in section of door lock or pull handle.

  5. Remove the #4 25mm screw and the #2 25mm screw on panel with a standard Phillips Screwdriver.
    • Remove the #4 25mm screw and the #2 25mm screw on panel with a standard Phillips Screwdriver.

  6. Pry Off Full Door Panel starting at bottom and working up the side, pulling fairly hard waiting. Clicking noises are a good sign the door panel is unlocking.
    • Pry Off Full Door Panel starting at bottom and working up the side, pulling fairly hard waiting. Clicking noises are a good sign the door panel is unlocking.

  7. Once door panel is free, remember to remove header from the tweeter in upper right hand corner of panel.
    • Once door panel is free, remember to remove header from the tweeter in upper right hand corner of panel.

  8. Remove bracket from door by unscrewing the two 14 mm nuts pictured here connected to the speaker unit.
    • Remove bracket from door by unscrewing the two 14 mm nuts pictured here connected to the speaker unit.

  9. Remove speaker from bracket by unscrewing the two #2 12mm screws using a Phillips head screwdriver.
    • Remove speaker from bracket by unscrewing the two #2 12mm screws using a Phillips head screwdriver.

  10. Desolder wires to new speaker unit using solder wick or a desoldering tool.
    • Desolder wires to new speaker unit using solder wick or a desoldering tool.

    • If you don't have experience soldering, make sure to check out this soldering guide.

    • Soldering uses high temperatures. Be careful not to damage the components or injure yourself in the process.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autres ont terminé cette réparation.

sdwelsh

Membre depuis le 04/05/2015

187 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 8-2, Regan Spring 2015 Membre de l'équipe Cal Poly, Team 8-2, Regan Spring 2015

CPSU-REGAN-S15S8G2

5 membres

7 tutoriels rédigés

Un commentaire

Are they 6.5 subwoofer lower door or 6×9

pauliemcfly25 - Réponse

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 27

Total : 2,599