Introduction
Use this guide to replace a 2012-2016 Honda Civic key remote battery.
Ce dont vous avez besoin
-
-
Lay the key down so that the Honda symbol is facing upward.
-
Use a Phillips #0 screwdriver to remove one screw.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
18 autres ont terminé cette réparation.
Équipe
Baylor, Team 5-7, Williams Spring 2015 Membre de l'équipe Baylor, Team 5-7, Williams Spring 2015
BU-WILLIAMS-S15S5G7
4 membres
9 tutoriels rédigés
26 commentaires
The original battery in my 2012 Honda Civic Key is a Panasonic CR1616, not a CR1620. I bought an Energizer CR1620, and it was too thick.
Thanks, Harry!
This isn't the same key remote that I have for my 2015 Civic Si (Sedan). Mine is more square shaped and the key is removable from the inside of the device. It also has no apparent opening-point anywhere around it. The only spot I would consider a possible entry point would be where the key is removed.
Robert;
Yes, once the key is removed it is just a matter prying it apart from between the two ears that stick up from the center. A fairly thick flat-bladed screw driver will do it (i used the handle end of a tweezer that was handy). This takes a CR2032 battery, (3) volt, very commonly found. There are two little tabs holding it in, plus (+) side up. Just snap it all back together. Voila.
arlen
Thank you very helpful!!!
