Introduction

The outer casing protects the internals of the monitor.

  1. Lay the monitor on a flat surface so that the back is facing up.
    • Lay the monitor on a flat surface so that the back is facing up.

    Ajouter un commentaire

  2. Grab the hinge cover with both hands on either side of the stand.
    • Grab the hinge cover with both hands on either side of the stand.

    • Squeeze inwards with your thumbs and fingers and lift up to remove the hinge cover.

    Ajouter un commentaire

    • Remove the four 12.1 mm Phillips #2 screws that hold the stand to the monitor.

    • Support the monitor while removing the screws to prevent the monitor from falling.

    • Lift up to detach the stand.

    Ajouter un commentaire

    • Remove the five 9.5 mm Phillips #2 screws located around the perimeter of the monitor.

    Ajouter un commentaire

    • Starting at the corner of the monitor, wedge the small plastic opening tool between the back cover and the display bezel.

    • Tilt the plastic opening tool up to separate the back cover from the display bezel.

    • Continue around the perimeter of the monitor until the display bezel comes off.

    • A reasonable amount of force is necessary to detach the back cover from the display bezel.

    Ajouter un commentaire

    • Reposition the monitor so that the back is facing up.

    • Grab the corners of the monitor and jiggle them upwards to detach the back cover from the inside of the monitor.

    • Lift the back cover up.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Keith

Membre depuis le 06/10/2011

261 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 20-26, Maness Fall 2011 Membre de l'équipe Cal Poly, Team 20-26, Maness Fall 2011

CPSU-MANESS-F11S20G26

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 4

Total : 947