Pièces

Aucune pièce nécessaire.

  1. Remove the battery Turn the laptop so that the lid touches the table and unscrew the screws. There are 14 long ones and 2 short ones.
    • Remove the battery

    • Turn the laptop so that the lid touches the table and unscrew the screws. There are 14 long ones and 2 short ones.

  2. Pop up the keyboard with a flat screw driver. Pay attention to the connector between the keyboard and the mother board. Disconnect the keyboard from the motherboard by lifting the black part of the FPC connector. Unscrew 8 screws.
    • Pop up the keyboard with a flat screw driver. Pay attention to the connector between the keyboard and the mother board.

    • Disconnect the keyboard from the motherboard by lifting the black part of the FPC connector.

    • Unscrew 8 screws.

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Disconnect the two flat cables with the FPC connectors as shown in the picture. Detach the lid and disconnect the sound card reader (red/black cable pair). Detach the lid and disconnect the sound card reader (red/black cable pair).
    • Disconnect the two flat cables with the FPC connectors as shown in the picture.

    • Detach the lid and disconnect the sound card reader (red/black cable pair).

  5. Unscrew the four screw in the screen lid. Slide out the 4 lockers on the side of the screen. Be careful not to have the screen touch the motherboard as it might scratch the surface of the screen. Slide out the 4 lockers on the side of the screen. Be careful not to have the screen touch the motherboard as it might scratch the surface of the screen.
    • Unscrew the four screw in the screen lid.

    • Slide out the 4 lockers on the side of the screen. Be careful not to have the screen touch the motherboard as it might scratch the surface of the screen.

  6. Disconnect the screen from the motherboard.
    • Disconnect the screen from the motherboard.

    • Connect the new screen and make sure to tape the cable to the screen (the connector should have a tape, if not, add one).

Conclusion

To reassemble your device, follow these instructions in reverse order.

contact@kbl.netlib.re

Membre depuis le 27/09/2018

313 Réputation

3 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 16

Total : 59