Introduction

This guide will lead you through the steps of removing the LCD monitor and its enclosure.

  1. Open and push the screen back all the way until it is horizontal with the rest of the laptop.
    • Open and push the screen back all the way until it is horizontal with the rest of the laptop.

    • Locate the panel above the keyboard that has the power button on it.

    • Remove this panel by using a spudger to pry up the sides.

      • You are using the spudger to release tabs holding the panel in place.

    • After you have used the spudger to release the tabs, lift up the panel.

    Ajouter un commentaire

  2. Under the panel, locate and remove the two screws that connect the keyboard to the laptop. One screw is located above the F5 button, and the other one is located above the F10 button.
    • Under the panel, locate and remove the two screws that connect the keyboard to the laptop. One screw is located above the F5 button, and the other one is located above the F10 button.

    • Lift up the keyboard CAREFULLY because there is a ribbon that connects the keyboard to the motherboard.

    Ajouter un commentaire

    • Release the catch on the ribbon socket, by sliding the two tabs toward the ribbon, then pull the ribbon, which is located under the keyboard, to detach it from the motherboard.

    • Remove the keyboard.

    do not pull on ribbon it will only break the cable. instead use tool to detach from mother board. i broke mine by pulling ribbon.

    steve foss - Réponse

    useless guide, there are a lot of screws that lock the cover on the laptop and you have never showed them

    Valerio Vischio - Réponse

    You do not need to remove the whole cover, in order to replace the keyboard.

    The description for this job is right.

    The switch plate cover just pops off.

    Screws revealed, secure the keyboard.

    Unclip the ribbon cable.

    Job done

    Richard -

  3. Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK au moment de payer
    Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK
    • Unscrew the 2 screws at each corner located underneath the LCD screen.

    Ajouter un commentaire

    • Locate the wire connecting the LCD screen to the motherboard.

    • Detach the white rectangle located on the motherboard at the end of the wire.

    Ajouter un commentaire

    • Place the laptop upside down.

    • Locate the largest removable panel on the back and remove the four screws connecting it.

    • Lift up and remove the panel.

    Ajouter un commentaire

    • Locate the black and white wire and detach it.

    • You do not need to remove the cooling fan

    Ajouter un commentaire

    • Lift up the monitor to detach it

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

7 autre(s) ont terminé cette réparation.

Brad Rollinson

Membre depuis le 29/09/2010

1 089 Réputation

7 tutoriels rédigés

Équipe

Cal Poly, Team 14-39, Forte Fall 2010 Membre de l'équipe Cal Poly, Team 14-39, Forte Fall 2010

CPSU-FORTE-F10S14G39

5 membres

9 tutoriels rédigés

There are 2 screws at the back corners on the bottom cover that are holding the screen down. They need to be removed in order for the screen to be lifted.

Kar Wong - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 6

30 derniers jours : 25

Total : 14,647