Introduction

Does your laptop fan make noise even after cleaning?

Here's how simple it is to change.

Pièces

Aucune pièce nécessaire.

  1. Retrieve all Screw's from the bottom of the laptop and organize them into 2 different sets. When removing the back cover gently press on audio connections on the back right of the laptop. When removing the back cover gently press on audio connections on the back right of the laptop.
    • Retrieve all Screw's from the bottom of the laptop and organize them into 2 different sets.

    • When removing the back cover gently press on audio connections on the back right of the laptop.

  2. %Livraison gratuite pour toute commande supérieure à 100,00 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

    Vous avez déjà réparé quelque chose ? Vous êtes un génie.

    Partagez votre réparation avec le hashtag #ImAGenius

    Nous sommes tous des génies

    Partagez votre réparation avec le hashtag #ImAGenius

  3. Carefully release and unplug every wire that connects to the fan. Carefully release and unplug every wire that connects to the fan. Carefully release and unplug every wire that connects to the fan.
    • Carefully release and unplug every wire that connects to the fan.

  4. Release the screw that connects the fan to the base of the laptop. Carefully remove your fan and heat sink. Apply heat paste to the center before replacing the fan and heat sink. Then reinsert the screw and plugs. Apply heat paste to the center before replacing the fan and heat sink. Then reinsert the screw and plugs.
    • Release the screw that connects the fan to the base of the laptop. Carefully remove your fan and heat sink.

    • Apply heat paste to the center before replacing the fan and heat sink. Then reinsert the screw and plugs.

Conclusion

To reassemble your device, follow these instructions in reverse order.

7 autre(s) ont terminé cette réparation.

JeanChristophe

Membre depuis le 19/11/2010

258 Réputation

1 tutoriel rédigé

May need to expand the "apply heat paste to center" section. Need to remove old paste first, etc. etc. A good bird's eye view intro, though

polishtext4 - Réponse

Tanks you…

I'll look forward for adding this info.

JeanChristophe -

Seemed like I was going to rip the motherboard up where the usb ports are by the audio connector, why isn't the %#*@ thing screwed down? Lol If I push down by the audio connector like you mention and pull it up from the other side will ot be fine, felt and looked like I might snap the board.

Clayton Boyle - Réponse

Good job, did have to Emphasis about releasing the audio connectors

Thaine Ferris - Réponse

I didn't know how to explain better…

Some trick of trade?

JeanChristophe -

Voir les statistiques:

Dernières 24 heures : 4

7 derniers jours : 10

30 derniers jours : 41

Total : 5,677