Introduction

You will have to remove several screws and a couple of cables on the bottom of the ZG5 to remove or replace the wireless card.

Pièces

Aucune pièce nécessaire.

  1. Turn the netbook upside down with the battery at the top, away from you.
    • Turn the netbook upside down with the battery at the top, away from you.

    Ajouter un commentaire

  2. Unlock the battery by sliding the switch located near the left hinge to the left "unlocked" position.
    • Unlock the battery by sliding the switch located near the left hinge to the left "unlocked" position.

    Ajouter un commentaire

    • Slide the latch located on the opposite hinge from the lock while pushing the battery up.

    Ajouter un commentaire

    • Gently loosen the two Phillips #0 screws in the small panel that covers the wireless card.

      • These screws are built into the panel and aren't meant to be completely removed.

    Ajouter un commentaire

    • Lift up the panel and remove it from the case.

    Ajouter un commentaire

    • Disconnect the two antenna cables from the left side of the wireless card.

    Ajouter un commentaire

    • Remove the single 3.9 mm Phillips #1 screw from the bottom left of the wireless card.

    Ajouter un commentaire

    • Gently lift up the left side of the wireless card and slide the card out of its socket.

    mi lap NO tiene wireless card

    gustavo cordova - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 autre(s) ont terminé cette réparation.

Doug Gallatin

Membre depuis le 05/10/2010

5 799 Réputation

10 tutoriels rédigés

Équipe

Cal Poly, Team 7-49, Amido Fall 2010 Membre de l'équipe Cal Poly, Team 7-49, Amido Fall 2010

CPSU-AMIDO-F10S7G49

5 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 7

30 derniers jours : 37

Total : 22,337