Introduction

The fan often needs replacement if the device is overheating or making loud noises while running. Some common tools will be needed for this replacement, such as a T6 Torx screwdriver and a Phillips #01 screwdriver. To determine if the fan needs to be replaced, please refer to this device's troubleshooting page.

Pièces

Aucune pièce nécessaire.

Remove the back panel by unscrewing all marked 3mm screws with a T6 Torx screwdriver.
  • Remove the back panel by unscrewing all marked 3mm screws with a T6 Torx screwdriver.

  • Remove these screws with a T6 Torx screwdriver, but note that these feet screws are 4mm in length.

Ajouter un commentaire

Unscrew the marked 2mm screws with a Phillips #01 screwdriver.
  • Unscrew the marked 2mm screws with a Phillips #01 screwdriver.

  • Remove the fan by disconnecting the marked tabs.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nicholas Wise

Membre depuis le 14/02/2018

595 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S2-G6, Eyestone Spring 2018 Membre de l'équipe USF Tampa, Team S2-G6, Eyestone Spring 2018

USFT-EYESTONE-S18S2G6

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 1

Total : 20