Introduction

If your battery will not charge fully, drains quickly, or shows inconsistent battery percentage this would be a good replacement. Prior to starting this guide, disconnect the power supply from the laptop.

Remove the nine 4mm screws with a PH0 screwdriver.
  • Remove the nine 4mm screws with a PH0 screwdriver.

  • Remove the two 6mm screws with a PH0 screwdriver.

Ajouter un commentaire

Remove the black rubber tab on the back of the computer
  • Remove the black rubber tab on the back of the computer

  • Remove the 4mm screw hidden underneath the black tab with a PH0 screwdriver.

Ajouter un commentaire

  • Orient the computer upside down, with the hinges facing away from you.

  • Find the black plastic piece in the SD card slot on the right side of the computer.

  • Remove the plastic piece by sliding it out of the SD card slot.

Ajouter un commentaire

  • Insert a spudger at these eight locations to disengage the plastic tabs from the housing cover, and pry apart.

    • Continue around the entire perimeter of the cover with the spudger.

  • Use a spudger to pry the cover around I/O ports.

Ajouter un commentaire

  • Remove the two 4mm screws using a PH0 screwdriver.

  • Depress the tabs holding the battery with a spudger.

  • Disconnect the battery connector from the motherboard using a spudger.

  • Pull the battery up and away from the laptop to remove.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Nat McCormick

Membre depuis le 15/02/2018

645 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S16-G1, Boczar Spring 2018 Membre de l'équipe USF Tampa, Team S16-G1, Boczar Spring 2018

USFT-BOCZAR-S18S16G1

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 11

Total : 67