Introduction

We well show you how to disassemble / take apart the tablet and how to change / replace the Touch screen. Before replacing, try to reconnect only the Touchscreen flex cable. Manual for this you can find on Acer Iconia B1 main page.


Please SUBSCRIBE to my channel ツ

Vidéo d'introduction

Because I can't switch-off the tablet, I'm using the reset button to do this.
  • Because I can't switch-off the tablet, I'm using the reset button to do this.

  • With a cutter and a plastic tool remove the back cover.

  • If you have a memory card inside, don't forget to remove it!

Ajouter un commentaire

First, disconnect the battery.
  • First, disconnect the battery.

  • Now, disconnect the loudspeaker and remove the back cover.

  • Remove all scotch tapes and disconnect the touch screen flex cable...

  • LCD display flex cable,

  • the microphone,

  • and the WiFi and Bluetooth antennas flex cables.

Ajouter un commentaire

  • Unscrew 5x screws and rmove the main board.

Ajouter un commentaire

  • The battery is glued to the LCD display metal shield with a double sided adhesive tape.

  • Use plastic tools and carefully remove it.

  • Remove all tapes from the LCD display metal shield.

Ajouter un commentaire

  • The LCD display is held by metal frame and some locking clips on it.

  • Use a cutter and a plastic tool to separate the LCD.

  • You have to work slowly so as not to break the display.

  • Now, install the new LCD display and reassemble the tablet.

Ajouter un commentaire

  • Warm up the touch screen.

  • Start separating from one of the corners. With a cutter, make place for a plastic tool.

  • Keep warm the touchscreen to separate it easily.

  • For us is important to keep only the frame.

Ajouter un commentaire

  • Use again hot air and a plastic tools to separate the metal screen frame / holder.

Ajouter un commentaire

  • Before installing the new touch screen, clean the frame and put double side adhesive tape.

  • For the cleaning you can use an alcohol.

Ajouter un commentaire

  • Again use a double side adhesive tape to install the the metal LCD frame.

Ajouter un commentaire

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 autre(s) ont terminé cette réparation.

ZFix

Membre depuis le 09/12/2013

156 676 Réputation

304 tutoriels rédigés

Équipe

Master Techs Membre de l'équipe Master Techs

Community

277 membres

749 tutoriels rédigés

Hello, i have followed all these instructions but the touch screen desn't work in spite of a reset by the little button and a wipe.

Please, how can i resolve this problem?

houssnijanah - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 22

30 derniers jours : 127

Total : 22,732