Introduction

The speaker plays back recorded sounds when you are watching video on the LCD screen of the device. Use this guide to replace the speaker.

  1. Locate the battery compartment on the back of the camera. It is the panel with the plastic ridges for simple removal.
    • Locate the battery compartment on the back of the camera. It is the panel with the plastic ridges for simple removal.

    • Slide the battery compartment cover down off of the camera body.

    Ajouter un commentaire

  2. Pry up the battery from the bottom using a finger and remove the batter from the case.
    • Pry up the battery from the bottom using a finger and remove the batter from the case.

    Ajouter un commentaire

    • Remove the lanyard by pulling the grey lace through the black string loop.

    • Pull black string loop through the silver bracket.

    Ajouter un commentaire

    • Use a plastic opening tool to pry off the black control cover.

    • The face plates are glued, so use force to pry the face plates from the camera body.

    Ajouter un commentaire

    • Use a plastic opening tool to pry off the ridged back face plate and the black button.

    • The face plates are glued, so use force to pry the face plates from the camera body.

    • The button is loose and should come off with little or no effort.

    Ajouter un commentaire

    • Use a plastic opening tool to pry off the silver face plate.

    • The face plates are glued, so use force to pry the face plates from the camera body.

    Ajouter un commentaire

    • Open the USB cover to expose the small machine screw.

    • Use the Phillips #00 screwdriver to unscrew the six 0.5cm machine case screws (distributed around the camera body).

    • These small screws are easy to lose. Place the removed screws in an organized container to avoid losing them.

    Ajouter un commentaire

    • Pull off the side control panel.

    Ajouter un commentaire

    • Flip open the screen by pulling the loose end of the screen away from the case.

    • Use tweezers to remove the two outside rubber dots to reveal the two 0.5cm machine screws.

    • Use the #00 Phillips Screwdriver to remove both screws.

    Ajouter un commentaire

    • Pull the body apart from the bottom of device just enough to make space to remove the silver plastic strap holder.

    • Use tweezers to remove the silver plastic strap holder.

    • Use a plastic opening tool to pry off the lens protector.

    Ajouter un commentaire

    • Unscrew the two silver 0.5cm machine screws with the #00 Phillips screwdriver.

    • Lift off the lens protector housing.

    • Pull apart the two halves of the camera body.

    • Do not pull the two halves apart too far because the wires may detach.

    Ajouter un commentaire

    • Use the #00 Phillips screwdriver to unscrew the two black speaker screws.

    • Lift off plastic cover.

    Ajouter un commentaire

    • Unplug the speaker from the circuit board by pulling out the white plastic connector.

    • Make sure to pull plastic connector and not wires because the wires could be damaged.

    • Lift out the speaker.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Zachary Yun

Membre depuis le 03/04/2012

7 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 5-5, Forte Spring 2012 Membre de l'équipe Cal Poly, Team 5-5, Forte Spring 2012

CPSU-FORTE-S12S5G5

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 1

Total : 352