Introduction

In this guide, we will show you how to remove and replace the Status-Light Board.

Outils

Aucun outil requis.

Pièces

Aucune pièce nécessaire.

Turn the computer off.
  • Turn the computer off.

  • Disconnect the charging cable from the computer.

  • Failure to unplug the charging cable could result in electric shock and serious injury.

  • Flip the computer upside down.

Ajouter un commentaire

Loosen the two 6.35 mm size 1 Phillips screws on the back cover.
  • Loosen the two 6.35 mm size 1 Phillips screws on the back cover.

    • The two screws are spring loaded and will not separate from the cover.

  • Slide the back cover towards you and then lift upwards to remove.

Ajouter un commentaire

  • Loosen the two 6.35 mm size 1 Philips screws attaching the battery to the laptop.

  • The two screws are clipped into the battery and will not detach.

Ajouter un commentaire

  • Pull up on the black tab on the battery to reveal the connection between the battery and laptop.

  • Pull up on the white connector to disconnect it from the laptop.

  • The battery is now free to remove from the laptop and can be set aside.

Ajouter un commentaire

  • WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before You Begin.

  • Turn the palm-rest assembly over.

Ajouter un commentaire

  • Note the routing of status-light board cable and remove the cable from the routing guides.

  • NOTE: If the status-light board cable is under the speakers cable, remove the speakers cable first and then remove the status-light board cable.

Ajouter un commentaire

  • Turn the palm-rest assembly over.

Ajouter un commentaire

  • Remove the screw that secures the status-light board to the palm-rest assembly.

Ajouter un commentaire

  • Carefully lift the status-light board and release its cable from the slot on the palm-rest assembly.

Ajouter un commentaire

  • Slide the NEW status-light board cable through the slot in the palm-rest assembly.

Ajouter un commentaire

  • Align the slot on the status-light board with the alignment post on the palm-rest assembly.

Ajouter un commentaire

  • Replace the screw that secures the status-light board to the palm-rest assembly.

Ajouter un commentaire

  • Turn the palm-rest assembly over.

Ajouter un commentaire

  • Route the status-light board cable through the routing guides on the palm-rest assembly.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Terrence15

Membre depuis le 18/12/2017

69 271 Réputation

444 tutoriels rédigés

Équipe

Informative Technologies Inc. Membre de l'équipe Informative Technologies Inc.

Community

15 membres

917 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 3

30 derniers jours : 8

Total : 59