1. Use screwdriver to pry off the stickers marked in red to reveal the location of the 4 screws.
    • Use screwdriver to pry off the stickers marked in red to reveal the location of the 4 screws.

    Ajouter un commentaire

  2. Remove the 4 screws to continue.
    • Remove the 4 screws to continue.

    Ajouter un commentaire

    • Pry the center of the mouse apart to separate the upper and lower housing of the boards.

    Ajouter un commentaire

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Remove the wires from the white crimp headers. this will separate the upper and lower housing units of the mouse.

    • Pull as far up on the wire as possible, being as careful as possible to avoid ripping the wires.

    Ajouter un commentaire

    • Take the upper housing of the mouse and begin to remove the two screws (highlighted in red) that hold the board in place.

    Ajouter un commentaire

    • Gently remove board.

    Ajouter un commentaire

    • The DPI button is the red push button highlighted in red.

    • To remove it, flip the board over and desolder the wires highlighted in orange.

    • Replace component with new component and resolder back in place.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Colin

Membre depuis le 10/02/2014

349 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 1-39, Maness Winter 2014 Membre de l'équipe Cal Poly, Team 1-39, Maness Winter 2014

CPSU-MANESS-W14S1G39

4 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 28

Total : 2,059