Pièces

Aucune pièce nécessaire.

Use the screwdriver to pry off the stickers marked in red to reveal the location of 4 screws.
  • Use the screwdriver to pry off the stickers marked in red to reveal the location of 4 screws.

Ajouter un commentaire

Remove the 4 screws to continue.
  • Remove the 4 screws to continue.

Ajouter un commentaire

  • Pry the center of the mouse apart to separate the upper and lower housing of the boards.

Ajouter un commentaire

  • Remove the wires from the white crimp headers. This will separate the upper and lower housing units of the mouse.

  • Pull as far up on the wire as possible, but be careful to avoid ripping the wires.

Ajouter un commentaire

  • Take the upper housing of the mouse and begin to remove the two screws (highlighted in red) that hold the board in place.

Ajouter un commentaire

  • Gently remove board.

Ajouter un commentaire

  • The side buttons are the red push buttons highlighted in red.

  • To remove them, flip the board over and desolder the leads highlighted in orange.

  • Replace components with new ones and resolder back in place.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andreas Apitz

Membre depuis le 23/01/2014

116 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 1-39, Maness Winter 2014 Membre de l'équipe Cal Poly, Team 1-39, Maness Winter 2014

CPSU-MANESS-W14S1G39

4 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 348