Introduction

This guide will be teaching you how to easily replace the modem in your computer.

Pièces

Aucune pièce nécessaire.

Pull the keyboard tabs toward you while lifting up on the keyboard until it releases from it's hold.
  • Pull the keyboard tabs toward you while lifting up on the keyboard until it releases from it's hold.

  • To lift the keyboard out pull it up and away from you. Then place the keyboard on the track pad.

Ajouter un commentaire

Pull the keyboard ribbon vertically from the logic board to release connection.
  • Pull the keyboard ribbon vertically from the logic board to release connection.

  • The connector may be tight and difficult to remove. If stuck try rocking the connector back and forth while pulling up until it releases. This same process can be used for many of the connectors on this device.

  • Remove battery and CD/DVD drives before proceeding any further.

Ajouter un commentaire

  • Your computer should look approximately like this.

Ajouter un commentaire

  • Remove the two silver Phillips #1 screws that attach the heat shield to the metal framework.

  • Lift the heat shield up and toward you.

Ajouter un commentaire

  • Pull the PRAM battery cable vertically upward to disconnect it.

  • Remove the battery by pulling up and to the left.

Ajouter un commentaire

  • Remove the two T8 Torx screws that attach the heat sink to the processor.

  • Remove the long silver Phillips #1 screw from the heat sink.

Ajouter un commentaire

  • Lift up the heat sink unit from the left side and remove.

Ajouter un commentaire

  • Lift the processor on the right side and pull directly up.

  • The RAM chips should be in the slots on the processor.

Ajouter un commentaire

  • After removing the RAM, your laptop should now look like this.

Ajouter un commentaire

  • Remove the single black Torx screw from the modem.

  • Remove the black rectangle that is being held on by the one Torx screw.

Ajouter un commentaire

  • Using your fingers, lift the modem from the socket it is plugged into.

Ajouter un commentaire

  • Disconnect the cable that is attached to the end of the modem to remove the modem.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Byron Hoefer

Membre depuis le 18/04/2011

70 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 4-2, Regan Spring 2011 Membre de l'équipe Cal Poly, Team 4-2, Regan Spring 2011

CPSU-REGAN-S11S4G2

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 957