Aller au contenu principal

Introduction

You need a Metal spudger and a screwdriver

Pièces

Aucune pièce spécifiée.

  1. Insert a metal spudger to open the plastic part under the Keyboard Insert a metal spudger to open the plastic part under the Keyboard
    • Insert a metal spudger to open the plastic part under the Keyboard

  2. Remove the screw
    • Remove the screw

  3. Fix Kits pour batterie de MacBook

    À partir de $69.99

    Buy Now

    Fix Kits pour batterie de MacBook

    À partir de $69.99

    Buy Now
  4. Pull the lock up and disconnect the connection cable Pull the lock up and disconnect the connection cable Pull the lock up and disconnect the connection cable
    • Pull the lock up and disconnect the connection cable

  5. Keeping the connection cable, push out the logic board's placement
    • Keeping the connection cable, push out the logic board's placement

  6. Unlock the latch of the logic board
    • Unlock the latch of the logic board

  7. Remove the logic board from the placement
    • Remove the logic board from the placement

Conclusion

To reassemble your device, follow these instructions in reverse order.

13 autre(s) ont terminé cette réparation.

Nicola

Membre depuis le 14/11/2013

470 Réputation

1 tutoriel rédigé

Hi, anyone know where its possible to buy this logic board? My bluetooth chip is apparently broken

steve - Réponse

Which model of keyboard is this, because my A1255 doesn't disassemble like this - the battery terminal is solidly restrained inside the tube by means of a metal expansion ring. Doesn't seem user repairable :(

gordon jackson - Réponse

My power button was stuck. The shell was dented. This was an easier way to access and remove the button so I was able to file the inside of the tube smooth so the button would move freely.

Tony - Réponse

I have disassembled my keyboard as shown above, but now I need a replacement Wireless Keyboard Logic Board. I have not been able to find one. Any suggestions?

Martin Rubio - Réponse

Very nice! in my case the flat cable was not properly connecting. I only found out when i opened the cap to the logic board and saw the cable sitting slanted in its connector. Put it back straight and now it works again. Cheers!!

mollymol - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 7

7 derniers jours : 49

30 derniers jours : 275

Total : 35,795