Introduction

This is a replacement guide for the Apple iSight webcam privacy lens. It will demonstrate step-by-step how to disassemble the webcam in order to access the privacy lens.

Pièces

Aucune pièce nécessaire.

Remove two 3.55 mm screws that hold the body to the ball and socket joint using the PH000 screwhead.
  • Remove two 3.55 mm screws that hold the body to the ball and socket joint using the PH000 screwhead.

Ajouter un commentaire

Insert the tweezers into the crevice of the ball and socket joint, and prop up the tabs to remove the white ring from the body.
  • Insert the tweezers into the crevice of the ball and socket joint, and prop up the tabs to remove the white ring from the body.

Ajouter un commentaire

  • Press the Apple logo through to pull apart the body frame from the body of the webcam.

Ajouter un commentaire

  • Remove the end cap with the Apple logo by simply pulling it off.

Ajouter un commentaire

  • Unscrew the 3 (3.55 mm) screws surrounding the black casing near the camera-lens.

Ajouter un commentaire

  • Using tweezers, remove the netting that surrounds the black casing.

Ajouter un commentaire

  • Pry open the top of the black casing and pull it off.

    • There is slot on each side just below the power cord connector.

Ajouter un commentaire

  • Unscrew 2 (4.41 mm) screws seen in the picture that surround the attachment of the lens to the main body.

Ajouter un commentaire

  • ,Pull the loose circuit strip from its connection using tweezers.

  • Do this for the side connection as well. This enables the entire camera lens section to come off.

  • Pull the camera lens section off the main body.

Ajouter un commentaire

  • Unscrew the final (4.41 mm) screw that connects the lens circuitry to the aperture.

  • Then pull off the circuitry top section.

Ajouter un commentaire

  • Pull off the top piece of the lens aperture.

  • Finally, remove the privacy lens using tweezers.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cullen Shorey

Membre depuis le 21/03/2018

157 Réputation

1 tutoriel rédigé

Équipe

IUPUI, Team S5-G1, Baechle Spring 2018 Membre de l'équipe IUPUI, Team S5-G1, Baechle Spring 2018

IUPUI-BAECHLE-S18S5G1

3 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 13

Total : 62