Aquarium Top Filter Box Replacement

Introduction

Use this guide to replace a cracked or broken filter box with a regular plastic box. This guide will provide you with the instructions and tools to repair your aquarium top filter. The added benefit you can achieve from this guide is that you can customize the filtration system best suited for your aquarium. The tools listed in this guide are easily accessible and can be found online or in any hardware store.

Ce dont vous avez besoin

Étape 1 Aquarium Filter Box

Aquarium Top Filter Box Replacement, Aquarium Filter Box: étape 1, image 1 de 2

Aquarium Top Filter Box Replacement, Aquarium Filter Box: étape 1, image 2 de 2

Using a black sharpie marker, mark the box for accurate holes.
Make sure the hole is a little bit smaller than the soft PVC pipe.

Modifier

Étape 2

Use the utility knife to cut a hole in the marked position to attach the pipe.
Be very careful as the box is difficult to cut.

Modifier

Étape 3

Using the same utility knife, make a hole in the bottom of the plastic box for the water to come out.
Be very careful as the box is difficult to cut.

Modifier

Étape 4

Attach the soft PVC pipe with the aquarium powerhead.
Make sure it is properly connected.

Modifier

Étape 5

Insert the soft PVC pipe in the plastic box.

Modifier

Étape 6

Aquarium Top Filter Box Replacement: étape 6, image 3 de 3

With a telfon tape properly wrap the soft PVC pipe for no leakage of water.

Modifier

Étape 7

Aquarium Top Filter Box Replacement: étape 7, image 3 de 3

Use aquarium-safe silicone glue to seal the soft PVC pipe with the plastic box.
Make sure to let the silicone glue dry for 30 minutes.

Modifier

Étape 8

Aquarium Top Filter Box Replacement: étape 8, image 3 de 3

Add your desired filter media best suited for your aquarium.
Finally, submerge the waterpump in water and adjust the waterflow.
Be careful were you place the inlet of the filter, so no organisms or substrate get sucked in and die inside or clog it. If needed you can put some filter floss or a sponge on the inlet to prevent the above.