Astak Mole Motor Replacement

Introduction

Replacing the motor requires access to the motherboard and it is suggested to place screws into magnetic tray to avoid loss of important screws. Removal of the rotational motor assembly is simple but it may be difficult to find a replacement motor online.

Ce dont vous avez besoin

Étape 1 Lower Case

Astak Mole Motor Replacement, Lower Case: étape 1, image 1 de 1

Remove the four bottom tabs in order to access the bottom screws.

Traduire

Étape 2

Remove all four 14 mm Phillips #1 screws.

Traduire

Étape 3

Remove the SD card.

Traduire

Étape 4

Pry up the motherboard on the four points using a spudger.
The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

Traduire

Étape 5

Gently pull back the motherboard to expose many of the component's wired connections.

Traduire

Étape 6 Electric Motor Assembly

Astak Mole Motor Replacement, Electric Motor Assembly: étape 6, image 1 de 1

Unscrew both screws using the Phillips head (PH1) screw bit and set aside for reassembly
Screw Measurements: Length: 7.1mm
The motor should be free of its housing and only be attached to the motherboard by its wires.

Traduire

Étape 7

Sever motor connection to motherboard and remove wire carefully.
Optional: Use electrical adhesive to prevent dislodging of new wired connection.
The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.