Aller au contenu principal

Introduction

If you getting a new antenna doesn't work, there might be a problem with the antenna connection inside the camera. This guide will show you how to replace input cable that attaches the antenna to the motherboard.

Pièces

Aucune pièce spécifiée.

  1. Remove the four bottom tabs in order to access the bottom screws.
    • Remove the four bottom tabs in order to access the bottom screws.

  2. Remove all four 14 mm Phillips #1 screws.
    • Remove all four 14 mm Phillips #1 screws.

  3. Remove the SD card.
    • Remove the SD card.

  4. Pry up the motherboard on the four points using a spudger.
    • Pry up the motherboard on the four points using a spudger.

    • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

  5. Gently pull back the motherboard to expose many of the component's wired connections.
    • Gently pull back the motherboard to expose many of the component's wired connections.

  6. Unscrew the antenna in a counter-clockwise rotation. Unscrew the antenna in a counter-clockwise rotation.
    • Unscrew the antenna in a counter-clockwise rotation.

  7. Take out the screw holding the antenna wire with the PH1 size Phillips head bit.
    • Take out the screw holding the antenna wire with the PH1 size Phillips head bit.

    • Screw length: 5.3mm

  8. Gently pry open the circuit board attached to the antenna wire using  a metal spudger.
    • Gently pry open the circuit board attached to the antenna wire using a metal spudger.

    • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

  9. Remove the antenna female end from the motherboard.
    • Remove the antenna female end from the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Meshari Alkhelaiwi

Membre depuis le 15/09/2016

143 Réputation

1 tutoriel rédigé

Équipe

USF Tampa, Team 2-2, Blackwell Fall 2016 Membre de l'équipe USF Tampa, Team 2-2, Blackwell Fall 2016

USFT-BLACKWELL-F16S2G2

4 membres

12 tutoriels rédigés

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 2

Total : 297