Aller au contenu principal

Astak Mole Camera Head Replacement

Ce dont vous avez besoin

  1. Astak Mole Camera Head Replacement, Lower Case: étape 1, image 1 de 1
    • Remove the four bottom tabs in order to access the bottom screws.

  2. Astak Mole Camera Head Replacement: étape 2, image 1 de 1
    • Remove all four 14 mm Phillips #1 screws.

  3. Astak Mole Camera Head Replacement: étape 3, image 1 de 1
    • Remove the SD card.

  4. Astak Mole Camera Head Replacement: étape 4, image 1 de 1
    • Pry up the motherboard on the four points using a spudger.

    • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

  5. Astak Mole Camera Head Replacement: étape 5, image 1 de 1
    • Gently pull back the motherboard to expose many of the component's wired connections.

  6. Astak Mole Camera Head Replacement, Camera Head: étape 6, image 1 de 1
    • Unscrew the three screws connecting the base to the camera head with the PH1 size Phillips head bit.

    • Screw measurements: Length=7.0mm.

    • The third screw can be exposed by rotating the camera head.

    • Do not force the camera head farther than it will allow you.

  7. Astak Mole Camera Head Replacement: étape 7, image 1 de 1
    • Unscrew indicated Phillips head screws using the PH1 Phillips head bit to free wires.

    • Screw measurements: Length=3.5mm

  8. Astak Mole Camera Head Replacement: étape 8, image 1 de 3 Astak Mole Camera Head Replacement: étape 8, image 2 de 3 Astak Mole Camera Head Replacement: étape 8, image 3 de 3
    • Separate the three indicated outputs from the motherboard with metal spudger.

    • There is electrical adhesive on the output. This can be easily separated with the metal spudger.

    • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

  9. Astak Mole Camera Head Replacement: étape 9, image 1 de 1
    • Separate the wire from CPU by cutting adhesive with metal spudger.

    • It is advised to reapply adhesive to wired connections during reassembly, and to re-attach wires to CPU to prevent disconnection and loose wires inside device.

    • Be careful not to damage the CPU in the process. This is not a wired connection.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Bryan

Membre depuis le 09/15/16

104 Réputation

1 tutoriel rédigé

Équipe

USF Tampa, Team 2-2, Blackwell Fall 2016 Membre de l'équipe USF Tampa, Team 2-2, Blackwell Fall 2016

USFT-BLACKWELL-F16S2G2

4 membres

12 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 5

Total : 454